Maintenance/Cleaning; Troubleshooting - LIVARNO LUX LSLB 20 A1 Bedienungsanleitung

LIVARNO LUX LSLB 20 A1

8. Maintenance/cleaning

Maintenance
The LED spotlight does not contain any components that require maintenance. The LED lamp cannot be
replaced.
Cleaning
DANGER! The electric circuit must be switched off during any work on the LED spotlight and
also during cleaning! There is a risk of electric shock!
DANGER! Ensure that no liquids are able to enter the housing of the solar LED spotlight.
There is a risk of electric shock.
Clean the LED spotlight using a soft, dry cloth, and never use cleaning agents or solvents that react with
plastic. If the LED spotlight is heavily soiled, use a very slightly moistened cloth.

9. Troubleshooting

The light does not go on
 The motion sensor (4) is not properly aligned. Correct its alignment.
 The electrical connection is faulty. Have the electrical connection checked by a qualified electrician.
The light goes on and off in rapid succession
 The sensor is experiencing interference caused by an external light source or bright, reflecting
surfaces. Remove the external light source or the surfaces that cause interference.
The light does not go off
 There are persons or objects in the sensor range of the motion sensor (4). Remove these.
 The LED spotlight is swaying in the wind, causing the motion sensor (4) to trigger continuously. Make
sure that the solar LED spotlight is firmly attached to a sturdy surface.
14 - English