Install/Replace Gas Bottle - Kärcher B 300 RI D Handbuch

5.4

Install/replace gas bottle

52
DANGER
Risk of injury!
Follow safety regulations for LPG vehicles.

Formation of crusts and yellow-frothing deposits on the

gas cylinder indicate leakiness.
Cylinders must be changed only by instructed persons.

Cylinders containing propellant gases must not be

changed in garages and underground areas.
Do not smoke and use uncovered light while changing

the cylinder.
While changing cylinders, first close the locking valve of

the LPG cylinder firmly and immediately put the protec-
tive cap on the empty cylinder.
WARNING
Only use replacement cylinders with 11 kg contents of test-
ed models.
ATTENTION
Do not open the gas drawing valve until before starting the
device (refer to chapter "Operation | Driving").
ATTENTION
Open the gas drawing valve by turning it in anti-clockwise
direction.
Gas bottle empty - replace gas bottle.
1 Panels
2 Lock
To open, press downward
3 Bracket closure
4 Gas cylinder
5 Support
6 Cover with driver seat
Tilt the cover upwards and secure it with the support.

Open the lock and swivel the cladding outwards.

Close gas drawing valve by turning it in clock-wise di-

rection.
Unscrew the gas hose (30-mm spanner).

Screw the protective cap onto the connecting valve of

the empty gas cylinder.
Open the cliplock.

Remove the empty gas bottle.

Replace the gas cylinder.
1 Gas withdrawal valve
2 Protective cover
3 Gas hose with union joint
4 Gas bottle holder
Place the gas bottle in the retainer.

Note
Observe the installation position of the gas cylinder.
The connection / ring opening must point downwards.
Close the bracket closure.

Unscrew the protective cap from the connecting valve

of the gas cylinder.
Screw the gas hose to the connecting valve of the gas

cylinder (30-mm spanner).
11
-
EN