Technical Data; Noise And Vibration - Ferm bsm1023 Bersetzung Der Orginalbetriebsanleitung

Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/5A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Sanding belt size
Sanding pad size
Protection class
Weight

NOISE AND VIBRATION

Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration (main grip)
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
Ferm
applications mentioned
-
-
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (fIg. A)
Your belt sander has been designed for rough
sanding applications on wood, metal, plastics and
painted surfaces.
1. On/off switch
2. Lock-on button
3. Sanding pad
4. Sanding belt roller
5. Clamping lever for sanding belt
6. Centring knob for sanding belt
BSM1023
7. Main grip
V~ 230
8. Auxiliary grip
Hz 50 9. Dustbag connection
10. Carbon brush holder
W 950
11. V-belt cover
m/min 380
mm 75 x 533
mm 76 x 135
ASSEMBLy
IP 20
3
kg 3.65
BSM1023
Mounting and removing the sanding belt
dB(A) 92.3
(fig. A & B)
dB(A) 103.3
Mounting
dB(A) 3
● Place the machine on its side with the V-belt
m/s 2.31
2
m/s 1.5
2
● Release the clamping lever (5).
● Mount a sanding belt (12) with the required
using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
cover (11) facing downwards.
grain size around the sanding pad (3) and the
sanding belt rollers (4). Make sure that the arrow
on the inside of the sanding belt points in the
same direction as the arrow on the housing.
- Use a coarse sanding belt (grain 50) for
sanding rough, uneven surfaces.
- Use a medium sanding belt (grain 80) for
removing the remaining scratches from the
coarse sanding belt.
EN
5