Optical Fibre Connection - Videotec MAXIMUS MHX Bedienungsanleitung

7.3.7 Optical fibre connection

Use a type of optical fibre suitable for the
receiver model installed.
Video and data transmission can be made via optical
fibre.
Connect the camera's video output to the CPU
board's J10 connector. Use the appropriate BNC-BNC
cable supplied.
J10
Fig. 30
For Multi Mode fibre transmitters use fibre
62.5/125μm with a maximum length of 3km (1.9mi).
MNVCMHX_1432_EN
For Single Mode fibre transmitters use fibre 9/125μm
with a maximum length of 69km (42.9mi).
Slide the fibre along the entry device.
Connect optical fibre with ST type connector.
Connect the optical fibre to the transceiver board by
paying attention to the bending radius.
Refer to the fibre receiver manual for remote control
of video and telemetry.
Fig. 31
27