Hoover H-Free 800 Bedienungsanleitung Seite 9

USING YOUR CLEANER
There are four working modes:
• TEMPORARY MODE: The product will start working when you press on the ON/OFF Switch and stop when released. [3A]
• CONTINUOUS MODE: To enable continuous mode you can pull switch lever back and it will click into place. [3B] To
disable continuous mode you can push the switch lever forward.
• SILENT MODE: Press the silent button to clean thoroughly at the lowest noise level for this product.
• TURBO MODE: Press the Turbo Button to fully power the product for hard cleaning tasks.
IMPORTANT: After each use of your product, please ensure to push the switch lever forward to the unlocked position.
Failure to do so may result in a reduction in battery life or failure.
WIFI SETUP
NOTE: This product features wifi connection to enhance the interaction with your cleaner. It allows to get statistics on
the usage of the product as well as additional info on how to use the product at its best. It allows to get notifications and
to monitor the overall maintenance in order to guarantee its performance.
Enrollment
You can switch the WiFi On/Off by pressing the WiFi button as shown in the diagram [4B]. The LED light will
continuously flash until the vacuum cleaner is connected to the Hoover Wizard App.
1. You can download the Hoover Wizard Application by scanning the QR code located on the cover of this manual.
2. Install it on your smart phone.
3. Follow the instructions in the App to setup your vacuum cleaner.
When installed correctly, your smart phone will connect automatically.
RESET WIFI
You can reset your vacuum cleaner by pressing the WiFi button for 5s until the LED light starts flashing.
You need to reconnect the vacuum cleaner to the APP again.
NOTE: once you lock the product by App, you can unlock it both by App or pressing "Turbo" and "Silent" button on the
product for 3 seconds at the same time.
SELECT SUITABLE ROLLER FOR BEST CLEANING
Intense Floor roller*: it is recommended to use on carpet which can go deep into the carpet to clean the dust.
Deep Care roller*: it is recommended to use on hard floor or delicate parquet. Thanks to the soft bristles you can gently
clean those type of floors.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
NOTE: To fit the Roller you would like to use: [17]
1. Detach the agitator release button flap. It is positioned on the lateral part of the nozzle.
2. Hold the agitator release flap and pull down to remove the agitator.
3. Replace with Intense Floor Roller or with the Deep Care Roller.
4. Re-fit in position the agitator release flap.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to
the soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front
slot. Lock the agitator release flap. [18]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product features an
integrated safety protection system.
NOTE: The Safety protection system will action if the agitator has a blockage or is locked, once actioned, the agitator
will stop rotating and the white Led lights on the front of the nozzle will flash around 10 seconds. If this happens, simply
turn off your product and clear the agitator obstruction. To resume cleaning, press the on/off button and the product will
start in normal mode.
* Certain Models Only
4
GB