Disposal; Kompernass Handels Gmbh Warranty - Silvercrest SBB 850 B2 Bedienungsanleitung

■ Wipe the exterior surfaces of the baking mould
with a moist cloth.
■ Clean the interior of the baking mould
warm water and a little dishwashing detergent.
If there are incrustations in the baking mould
fill the baking mould
dishwashing detergent. Let it soak until the incrus-
tations have softened and can be removed with
a dishwashing brush. Afterwards, rinse the baking
mould with clean water and dry it off thoroughly.
■ Clean the measuring cup
spoon and the kneading blade remover
warm water with a little mild washing-up liquid.
Then rinse all parts with plenty of clean water
to remove all detergent residues. Dry everything
thoroughly.

Disposal

Never dispose of the appliance
in the normal domestic waste.
This product is subject to the
provisions of European Directive
2012/19/EU.
Dispose of the appliance through an approved
disposal centre or at your community waste facility.
Please observe applicable regulations. Please
contact your waste disposal facility if you are in
any doubt.
Dispose of all packaging materials in an
environmentally friendly manner.
SBB 850 B2
with
with water and add mild
, the measuring
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
,
the date of purchase. If this product has any faults,
you, the buyer, have certain statutory rights. Your
statutory rights are not restricted in any way by the
warranty described below.
Warranty conditions
The validity period of the warranty starts from the
in
date of purchase. Please keep your original receipt
in a safe place. This document will be required as
proof of purchase.
If any material or production fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
at our discretion. This warranty service is depend-
ent on you presenting the defective appliance and
the proof of purchase (receipt) and a short written
description of the fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair
or replacement of a product does not signify the
beginning of a new warranty period.
Warranty period and statutory claims for
defects
The warranty period is not prolonged by repairs
effected under the warranty. This also applies to
replaced and repaired components. Any damage
and defects present at the time of purchase must
be reported immediately after unpacking. Repairs
carried out after expiry of the warranty period shall
be subject to a fee.
GB │ MT │ 81 ■