Troubleshooting - Madison MAD-HIGHPOWER300 Bedienungsanleitung

Specifications
MAD-HIGHPOWER300
Max. power 250W
RMS power 125W
Woofer 2 x 5"/13cm
Freq. range 40Hz-18kHz
S/N ratio ≥60dB
Power supply 9Vdc via supplied mains adaptor
Built-in battery 2Ah
Dimensions 200 x 220 x 410mm
Weight 2.9kg
The product design and specifications may be changed without prior notice!

Troubleshooting

Problem Possible cause
No sound output 1: No input sound source
when power on 2: Volume in the lowest position
3: USB/SD not connected
Distortion of sound 1:Volume too loud
2: Audio file error
No sound from the 1:Microphone socket not fully plugged in
Microphone 2: Microphone switch is not on
3: Microphone volume too low
No sound from the 1:incompatible song format
USB/SD card 2: Illegal operation causes failures
3:USB/SD Card not inserted properly
Speaker has big 1:Wired Microphone too close to the
noise speaker
2:Wired Microphone is switched on but
not in use
3: Microphone volume too loud
4:Mobile phone too close to the speaker
5:Too close to the equipment which
interferes with the speaker
Blue-connect 1: Blue-connect Disconnected
Failure 2: Blue-connect Connected but no voice
3: Blue-connect effective distance too
Remarks: If the problem persists, please contact your dealer.
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
©Copyright Lotronic 2018
short
Solution
1:Connect a Line signal
2: Adjust volume
3: Insert a USB/SD Card
1:Turn volume lower
2:Check and change the audio file
3: Adjust Bass/Treble by "MENU" and "Main volume"
1:Completely plug in the microphone socket
2:Power on microphone
3:Adjust microphone volume
1:songs format should be MP3/WMA
2: Power off, then power on
3:Insert USB/SD card properly
1:Do not let the wired microphones head point at the
speaker
2:Turn off wired microphone if not in use
3:Reduce the microphone volume
4: Keep mobile away from the speaker during calls
5:Keep the speaker away from other sources of interference
1: Find the right device Name or press "MENU" Button to
restore factory settings.
2: Confirm if you are connected to the right device Name
3: Try to keep away from barriers, such as walls, glasses...etc
MAD-HIGHPOWER300 3