Inhaltsverzeichnis
Werbung
g
Setting up
Use the tripod supplied to set up the device or to mount on a wall or
ceiling.
Screw the tripod into the thread connection
device.
Fixing to a wall/ceiling
Place the feet of the tripod onto the base and mark the drill holes.
If the device is to be fixed to a wall, drill holes and insert the dow-
els supplied.
Fix the feet of the tripod with the screws supplied.
Screw the tripod into the thread connection
device.
Roughly align the camera.
NOTE
►
The exact alignment of the camera takes place after installing
the configuration software onto your computer.
Electrical connection
For safe and trouble-free operation of the device, the following in-
structions have to be observed for the electrical connection:
■
The device is supplied with 5 Volt DC voltage via the mains
adapter supplied. Always use the mains adapter supplied to con-
nect the device to the mains supply.
■
Before connecting the device, compare the connection data (volt-
age and frequency) on the rating plate with those of your mains
adapter. This data must correspond in order to avoid damage to
the device.
■
Protect the adapter cable from hot surfaces and sharp edges.
■
Make sure that the power cable is not stretched tightly or twisted.
■
Do not allow the adapter cable to hang over edges (danger of
tripping).
■
If the device is not to be used for a longer period of time, discon-
nect the mains adapter from the mains supply.
68
Installation and connection
5
on the back of the
5
or the back of the
00053157
Werbung
Inhaltsverzeichnis
