Using The Device - Navitel G550 Benutzerhandbuch

4 | USER MANUAL

Using the device

1. Power supply and charging
Power supply
There are three types of power supply: battery, adapter, USB ca-
ble. The GPS navigator uses its built-in Lithium battery when it
is not connected to an external power supply via the adapter;
external power when it is connected to motorcycle or car; the
EN USB cable to charge when connected to a PC.
Note: this device uses built-in, unchangeable Lithium battery.
Battery time may vary, depending on which functions are used.
For example, bright backlight will consume more energy, which
will reduce battery time.
To avoid fire or explosion, please do not poke, bump or take the
battery apart, and do not throw it into burning fire, or water.
Using the charger
Connect the red and black wires to the motorcycle's electrical
system. Connect the other part to the charging port of the
device.
When you start the motorcycle, the GPS navigator will turn on
automatically.
2. Power on/off
Power on
Please, make sure that the battery has enough charge or is
connected to an external power source.
Note: when travelling, keep in mind that the device needs
time to adapt to a different environment before you turn it
on. Sudden increase or decrease in humidity may cause the
mainframe to short circuit.
Power off
Press the button at the top of the device to turn it off; the device
will enter power saving mode. When turned on again, it will re-
store its last state.
3. Resetting the system
If the device is not responding or is not working properly, you
can reset it by using the stylus to press the reset button on the
right side of the device.
Note: the unsaved data will be lost if your reset the system
while it is not responding. It is recommended to make regular
backups.