Connections; A) Connecting The Cables; B) Connecting The Motor Point Pen; C) Charging - CefarCompex Physio 5 Bedienungsanleitung

2 - Connections

A) Connecting the cables

The stimulator cables plug into the 4
sockets on the base of the device. All 4
cables can be connected simultaneously.
Both the +/- buttons and the cables
are colour-coded to simplify use and
facilitate identification of the different
channels.
The kit includes four 2,1 mm pin-
connector cables and 8 pin to snap
converters.

B) Connecting the motor point pen

Never use the motor point pen for
any purposes other than locating the
motor point of the muscle. Follow the
instructions in this manual. Clean and
disinfect the tip of the motor point pen
that comes in contact with the skin
before each use. Apply a small amount
of gel to the skin when looking for the
motor point to enhance patient comfort.
Refer to the picture above to see how to
connect the pen.
Connect the tip of the motor point pen
(preferably to the red connector). The
other connector must be connected to
an electrode already on the muscle to be
stimulated.

C) Charging

The Physio5 is a portable muscle
stimulator powered by a rechargeable
battery unit.
Recharging
To recharge the Physio5, first disconnect
the electrode cables from the device,
then plug the charger to a wall socket
and finally connect the stimulator to the
charger.
The charge menu illustrated below
appears automatically.
1a: The stimulator has been charged for
7 minutes and 27 seconds (a full charge
may take 2-2,5 hours with the rapid
charger delivered with your device).
1b: Charging is in progress. When charg-
ing is completed, total charge duration
flashes and the battery symbol is com-
pletely full. The stimulator switches off
automatically as soon as you disconnect
the charger.
1a 1b
ENG
8