Applicable Controls - Toshiba RAV-SM562BT-E Installations-Handbuch

10

APPLICABLE CONTROLS

When using the equipment at the first time, it will take a lot of time that the remote controller accepts an
operation after power was on. However, it is not a trouble.
• Automatic address
• While automatic addressing, the operation cannot be performed on the remote controller.
• For automatic addressing, Max. 10 minutes (generally, approx. 5 minutes) are required.
• When power will be turned on after finish of automatic addressing;
• It will require Max. 10 minutes (generally, approx. 3 minutes) that outdoor unit starts operation after power
was on.
As all the buttons have been set to [Standard] at the shipment, change the setup of the indoor unit if necessary.
To change the setup, use the main remote controller (wired remote controller).
* The setup change for wireless remote controller, sub remote controller, or remote controller-less system
(Central control remote controller only is provided.) is impossible. In these cases, prepare and mount a
separate main remote controller.
Changing of applicable control setup
Basic operation procedure for setup exchange
Change the setup while operation of the equipment stops.
(Be sure to stop the operation of a set.)
Procedure
When pushing
flashes as shown in the figure.
Check that the displayed CODE No. is [10].
• If the CODE No. indicates other than [10], push
1
the display, and then retry the operation from the first step.
(For some time after
the remote controller cannot be accepted.)
(In a group control, the firstly displayed
indoor unit No. becomes the master unit.)
Every pushing
Select an indoor unit of which setup to be changed.
2
In this time, the position of the indoor unit of which setup to
be changed can be confirmed because the fan of the selected
indoor unit work.
Using
3
Using ,
4
SET
Push button. In this time, if the display changes from flashing to lighting, the setup completes.
• To change the setup of an indoor unit other than the selected one, start operation from Procedure
5
• To change the setup of another setup in the selected indoor unit, start operation from Procedure
CL
Pushing
When settings have been completed, push
settings. When
6
content disappears and the air conditioner enters the normal stop mode.
(While "SETTING" is flashing, no operation of the remote controller is
accepted.)
NOTIFICATION
SET CL TEST
, , and buttons simultaneously for 4 seconds or more, after a while, the display part
TEST
button has been pushed, the operation of
UNIT LOUVER
button, the indoor unit No. in the group control is displayed successively.
, buttons of set temperature, specify the CODE No. [
buttons of set timer, select set data [
button clears the set up contents which have been already set. In this case, retry from Procedure
TEST
button is pushed, "SETTING" flashes and then the display
4
6
1
Description
TEST
button to erase
(* The display changes according to the indoor unit model.)
**
].
****
TEST
button to determine the
22
].
3
5
2
2
.
3
.
2
.