Inhaltsverzeichnis
Werbung
5. Note the orientation of the eSATA connector or IEEE 1394 connector and route the eSATA connector or
IEEE 1394 connector cable into the cable clip.
6. Place the eSATA connector or IEEE 1394 connector into the metal retainer. Then insert the eSATA
connector or IEEE 1394 connector into the corresponding slot in the flex module as shown.
Figure 42. Installing the eSATA connector or IEEE 1394 connector in the flex module
7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 43. Reinstalling the flex module cover
8. Connect the eSATA connector or IEEE 1394 connector cable to the corresponding connector on the
system board. See "Parts on the system board" on page 35.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.
Front Thunderbolt adapter kit
The front Thunderbolt adapter kit includes the following parts:
• A front Thunderbolt I/O adapter
.
Chapter 9
Installing or replacing hardware
117
Werbung
Inhaltsverzeichnis
