Optical Drive - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

6. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Figure 29. Installing a memory module
7. Reinstall the PCIe x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.

Optical drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Note: For some computer models, the optical-drive bay might be installed with an optical drive, a Multi-drive
Conversion Kit, or a Slim Optical Drive Adapter.
To install or replace an optical drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Remove the front bezel. See "Front bezel" on page 92.
3. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing an optical drive, do the following:
a. Remove the metal static shield from the desired drive bay.
104
P320 Hardware Maintenance Manual
2 in the slot. Push the memory module straight down into the slot until
1 on the memory