Power Button - Lenovo ThinkStation P320 Hardwarebedienungsanleitung

Power button

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the power button, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Remove the front bezel. See "Front bezel" on page 92.
3. Locate the power button. See "Computer components" on page 31.
4. Disconnect the power button cable from the power button connector on the system board. See "Parts
on the system board" on page 34.
5. Remove the screw that secures the power button to the front bezel. Then, remove the power button
from the front bezel.
Figure 15. Removing the power button
6. Position the new power button so that the screw hole in the power button is aligned with the
corresponding hole in the front bezel. Then install the screw to secure the power button to the front bezel.
Figure 16. Installing the power button
.
Chapter 9 Hardware installation and replacement
95