Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTIONS FOR USE
Before each utilisation, wash your hands accurately and clean the device as described in the paragraph
"CLEANING, SANITISATION, DISINFECTION AND STERILISATION (for hospital use)". The parts (A7-A9-A10-
C2-C3) are for personal use only to avoid potential risks of transmitting infection. It is recommended to replace
them every six months.
1. Insert power supply cord (A12) into socket (A11) and then connect it to a mains outlet adequate to the de-
vice voltage. The position of the socket must be such that the device can be easily unplugged from the mains
network.
A10
B5
A7
A6
A5
A4
C2
C3
17040A0_ interno.indd 3
A9
A8
A10
A4
A13
A9
A10
B5
1. Connect tube A10 to the pulsed air outlet A4 and tube
A7 to the pressure switch inlet. A6
2. Insert the cable plug B5 into the power socket B4 of the
Ultrasonic Nebuliser Device.
3. Screw the ring nut by turning it clockwise.
WARNING
The protection cap of the 15Vdc socket must be removed
to insert the plug and must be replaced after use to pro-
tect the socket.
1. Connect mouthpiece C2 to PEP connector C3
2. Connect the two tubes A9-A10 coming out of A4-A8 to
PEP connector C3
3. Insert cable plug V1coming out of A5 into socket ultra-
sonic nebuliser device.
4. Place the plug on power supply cable A12 into socket
A11 on the device.
5. Attach tubes A9-A10 and cable B5 to the proper hooks
A13 as shown in the detail.
3
13/07/2016 15:00:53
Werbung
Inhaltsverzeichnis
