High Power Operation; Timer Operation - Toshiba RAS-M10GDCV-E Betriebsanleitung

HIGH POWER OPERATION

High power (Hi POWER)
• The High power (High power operation) mode automatically controls room
temperature, operation mode so that the room is quickly cooled in summer and
warmed in winter. (Refer to page 16.)
Setting High power mode
a Hi-POWER button
Push the Hi-POWER button.
The "Hi POWER" mark on the remote controller is indicated.
Canceling High power mode
a Hi-POWER button
Push the Hi-POWER button once again. The "Hi POWER" mark on the remote
controller goes out.
CAUTION
The High POWER mode cannot be activated in the DRY and FAN ONLY
operation and when the ON TIMER operation is reserved.

TIMER OPERATION

ON timer and OFF timer
Setting TIMER
a ON/OFF TIMER button
Push the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes along with ON/OFF TIMER
display.
b TIMER
button
Push the TIMER button.
Set the timer to the desired time.
Each push of the TIMER button changes the time in ten minutes steps. Pushing
the TIMER button continually changes the time in one hour steps.
c SET
button
Push the SET button to set the timer.
The timer time is indicated and the timer starts.
d CLR
button
Push the CLR button to cancel the timer setting.
CAUTION
• When you select the timer operation, the remote controller automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote controller in a location where it can transmit the signal to the switch panel properly.
• If you do not push the SET
Once you select the timer operation mode, the settings are saved in the remote controller. Thereafter, the air conditioner will start
operating under the same conditions when you simply push the ON/OFF button of the remote controller.
If the clock display is flashing, you cannot set the timer. Follow the instructions in the section "Setting the clock" on page 8 to set the
clock, and then set the timer.
EN
button within 30 seconds after setting the time, the setting will be cancelled.
12