Philips HQC684 Bedienungsanleitung Seite 3

C
C
.
.
.
2 Insert the appliance plug into the appliance.
3 Insert the mains plug into the wall socket.
The pilot light will go on to indicate that the appliance is charging.
B
This appliance is suitable for mains voltages from 220 to 240 Volts.
B
Only use the cord supplied with the appliance.
B
Do not charge the appliance for more than 24 hours.
A fully charged appliance has a cordless operating time of up to 30
minutes.
Optimising the lifetime of the battery
- After the appliance has been charged for the first time, do not
recharge it between clipping sessions. Continue using it and recharge
it only when the battery is (almost) empty.
- Discharge the battery completely twice a year by letting the motor
run until it stops.
- Do not keep the cord plugged into a wall socket all the time.
- If the appliance has not been used for a long period of time, it must
be recharged for 8 hours.
Corded clipping
To use the hair clipper connected to the mains:
Switch the hair clipper off, connect it to the mains and wait a few
seconds before switching it on.
If the battery is completely empty, wait a few minutes before switching
the appliance on.
Do not run the appliance from the mains when the battery is fully
charged.
Preparing for clipping
Also see the interactive instruction CD-ROM.
Clipping with comb attachment:
Select the small or large comb attachment, depending on the desired
hair length.
Hair length settings
The hair length settings are indicated in millimetres on the arms
of the comb attachment.The settings correspond to the remaining
hair length after cutting.
- The small comb cuts hair to a length of 4 mm, 7 mm, 10 mm,
13 mm, 16 mm, 19 mm or 21 mm.
- The large comb cuts the hair to a length of 24 mm, 27 mm, 30 mm,
33 mm, 35 mm, 38 mm or 40 mm.
ENGLISH
5