Lubrication; Attaching / Removing A Dust Extraction Device; Operation; Cutting Guide - Parkside PDBG 125 A1 Bedienungs- Und Sicherheitshinweise

Lubrication

Q
This product features a lubrication system utilizing
wax sticks to clean and lower friction between
23
the two blades rotating in counter-direction.
1. Insert a wax stick 23
holder (see fig. E).
4
2. Turn the wax stick dial
touches the blades.
3. Slightly turn the wax stick dial
clockwise to create a little clearance between
wax stick and blades.
23
4. Occasionally turn the wax stick dial
slightly clockwise during operation to
lubricate the blades.
Attaching / removing a dust
Q
extraction device
WARNING!
During operation fine dust will be generated!
u
Some dusts are highly inflammable and
explosive! Always attach a dust extraction
device when using this product in order to
keep the working area clean! Wear a dust
mask when operating this product! Dust can
be harmful to health! Especially dust and
chips of wood that has been treated, e.g.
with wood preservative or a stain!
Do not smoke during operation, keep heat
u
sources and open flames out of the working
area!
This product features a designated dust extraction
outlet to connect a vacuum cleaner reducing
12
generated dust during operation on the workpiece
and airborne.
1. Slide the dust extraction adaptor
dust extraction outlet
snug.
2. Rotate the dust extraction adaptor
needs (see fig. F).
3. Remove the dust extraction adaptor
work by simply pulling it off.
into the wax stick
clockwise until it
3
counter-
3
3
24 over the
, make sure it sits
12
24 to your
after
24

Operation

Q
CAUTION! RISK OF INJURY!
Keep your hands away from the tool when
u
the product is in operation.

Cutting guide

Q
The cutting guide can be adjusted for different
5
working positions.
1. Use the provided multi-tool
cutting guide screw
2. Turn the cutting guide
position.
3. Use the provided multi-tool
cutting guide screw

Switching on and off

Q
Switching on:
1. Push the lock-off button
2. Press the on / off switch
button once the product is running.
15
Switching off:
1. Release the on / off switch
product off.

Cutting

Q
This product features two counter-rotating blades,
cancelling each other's pull force out, which makes it
ideal to perform cross and pocket cuts safely.
Cross cut
NOTE
Always perform a trial cut into scrap
u
material along a marked cutting line on the
workpiece. The cutting guide indicates where
the cut will be made.
1. Secure the workpiece with suitable means.
2. Hold the product firmly with both hands on the
rear handle and front handle
14
3. Switch on the product (see "Switching on and
off"). Let the blades reach full speed.
4. Guide the product into the workpiece to make
the cut.
5. Switch off the product and let the blades come to
full stop.
6. Lift the product off the workpiece.
7. Fig. H: rip cutting of chipboard or plywood (left);
cross cutting of natural timber (right).
8. Fig. I: cross cutting of a copper pipe (left);
cross cutting of an aluminum bar (right).
to loosen the
22
6 (see fig. G).
to your desired
5
22 to tighten the
.
6
15 and keep it pressed.
. Release the lock-off
13
13 to switch the
.
1
GB / CY 13