General Safety Directions For Power Tools - Parkside PWSA 18 A1 Originalbetriebsanleitung

GB
Green LED flashes with battery:
Battery has to be charged in advance for
30 minutes before charging starts
Red and green LED flashes
Red and green LED lights up
Battery too cold or too warm. Battery can-
not be charged
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols (the instruction is
explained at the place of the excla-
mation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.
General Safety Directions for
Power Tools
WARNING! READ ALL SAFETY
DIRECTIONS AND INSTRUC-
TIONS. Omissions in the compliance
with safety directions and instructions
can cause electrical shock, fire and/
or severe injuries.
Retain all safety directions and in-
structions for future use.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool).
1) Work area safety :
a) Keep work area clean and well
lit. Cluttered or dark areas invite acci-
dents.
b) Do not operate power tools in
8
Battery defect
c) Keep children and bystanders
2) Electrical safety :
a) Power tool plugs must match the
b) Avoid body contact with earthed
c) Do not expose power tools to rain
d) Do not abuse the cord. Never use
e) When operating a power tool out-
explosive atmospheres, such as
in the presence of flammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
away while operating a power
tool. Distractions can cause you to lose
control.
CAUTION! The following states how
to avoid accidents and injuries due to
electric shock:
outlet. Never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of electric
shock
or grounded surfaces, such as
pipes, radiators, ranges and re-
frigerators. There is an increased risk
of electric shock if your body is earthed or
grounded.
or wet conditions. Water entering a
power tool will increase the risk of electric
shock.
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged or
entangled cords increase the risk of elec-
tric shock.
doors, use an extension cord suit-
able for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of