Overview; Scope Of Delivery; Initial Operation; Assembly - FLORABEST FHA 1100 A1 Originalbetriebsanleitung

Overview

1 Water outlet, automatic switch
A
2 Power cable, automatic switch
3 Water outlet, home water dis-
penser
4 Water inlet, home water dis-
penser
5 On/Off switch
6 Power cable, home water dis-
penser
7 Home water dispenser
8 Carrying handle
9 Water inlet, automatic switch
10 Automatic switch
11 Restart switch
12 "Power On" indicator
13 "Pump On" indicator
14 "Alarm" indicator
15 Rest
16 Thread of rest screw
17 Draining screw

Scope of Delivery

- Home water dispenser
- Automatic switch
- Rest

Initial Operation

Assembly

• Screw the rest (15) from the package
into the thread (16) in the bottom of
the home water dispenser (7).
• Push the carry handle (8) onto the
carry handle holder and screw these
together using the screws with was-
hers. To do this, use the hex key.
• To permanently install the home wa-
ter dispenser, screw it to the ground.
Screwing it to a fixing panel will pre-
vent the appliance from moving.
Mind not to obstruct the access to the
draining screw (17).
• Connect the home water dispenser's
A
power cable (
automatic switch (

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is
intended for connection to an earthed
socket at 230 V ~ 50Hz.

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
• Always put up the home water dis-
penser at a point higher than the
water surface you wish to pump water
from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suc-
tion hose.
• Remove the cap from the home water
dispenser's water outlet (
the automatic switch (
home water dispenser's water outlet
A
( 3).

Connecting the hoses

On the suction side, attach a hose
with reflow stopper and install a
prefilter. On the suction side, do
not use any quick-action connec-
tion systems.
• Attach a suction hose to the home water
dispenser's water inlet fitting (
• Attach a pressure hose to the automatic
switch's water outlet fitting (
Air in the suction hose will stop the
house water dispenser from work-
ing properly.
GB MT
6) to the socket of the
B
18).
A
3). Mount
A
10) on the
A
4).
A
1).
31