Preparation; Requirements For Aromatic Coffee; Brewing Coffee With Coffee Powder; Brewing Coffee With Coffee Beans - Beem Fresh-Aroma-Perfect Deluxe V2 Bedienungsanleitung

BEEM - Elements of Lifestyle
The drip protector prevents water running
‹
out of the filter when the thermos jug (7) is re-
moved from the appliance. During the brew-
ing process however, the thermos jug (7)
should not be removed from the appliance
for more than 30 seconds, otherwise the filter
will fill up and the coffee will overflow.

Preparation

Requirements for
aromatic coffee
In order to prepare aromatic coffee, please
observe the following instructions:
Fill the water tank with the amount fresh
‹
water required for the desired number of
cups.
If possible, use freshly ground coffee
‹
powder to assure optimum flavour.
Experiment with the amount of coffee
‹
powder until you find the flavour you prefer.
Try various different levels of grinding
‹
fineness for the coffee powder. The grinding
fineness for the coffee powder influences the
aroma of the coffee.
Remove and clean the permanent filter
‹
after each use.
Clean and descale the appliance at regu-
‹
lar intervals. A dirty and/or scaled appliance
impairs the aroma.
Brewing coffee with
coffee beans
NOTE
► Activate the display lighting by pressing
any key. The lighting goes off 60 seconds
after the last button was pressed.
1. Fill with water as described in the section
Filling with water (pag. 17).
2. Fill with coffee beans as described
in the section Filling with coffee beans
(pag. 17).
3. Insert the permanent filter as described in
the section Inserting the filter (pag. 17).
4. Select the desired number of cups as de-
scribed in the section Setting the number of
cups (pag. 17).
5. Set the desired strength of coffee as
described in the section Setting the coffee
strength (pag. 18).
6. Set the grinding fineness as described in
the section Setting the grinding fineness
(pag. 18).
7. Press the
the grinder.
The indicator lamp (19) is lit; the freshly
ground coffee powder is passed through the
shaft of the grinder into the filter compartment
(8), and the coffee is brewed.
8. When the brewing process has been
completed, the power indicator (19) goes out.
The appliance is switched off.
Cancelling the brewing process
1. Press the
brewing process and switch off the appliance.
The indicator lamp (19) goes out; the appli-
ance is switched off.
Brewing coffee with
coffee powder
NOTE
► Activate the display lighting by pressing
any key. The lighting goes out 60 seconds
after the last button was pressed.
1. Fill with water as described in the section
Filling with water (pag. 17).
2. Insert the permanent filter as described in
the section Inserting the filter (pag. 17).
With the help of the measuring spoon sup-
plied (1 level spoon per cup), fill the filter with
the desired amount of coffee powder.
3. Press the button (26) to start brew-
ing coffee.
The power indicator
coffee is brewed.
4. When the brewing process has been
completed, the power indicator (25) goes
out. The appliance is switched off.
EN 19
button (20) to switch on
button (20) to cancel the
(25) lights up, the