Olympica Nova Wall; Grille; Positioning The Speakers - Sonus Faber Olympica Nova series Handbuch

3.2.4 OLYMPICA NOVA WALL

This loudspeaker is intended for wall assembly. Perform the fixing operations as follows. Refer to Fig. 5.
1. Using the bracket supplied as a drilling template, use a pencil to mark the points to be drilled on the wall.
2. Drill the holes and insert the four plugs supplied.
3. Assemble the bracket on the wall, using the four Phillips screws supplied.
4. Assemble the loudspeaker on the bracket. Refer to Fig. 5C and 5D
5. Insert the nylon washer into the bracket lower pin. Refer to Fig. 5E.
6. Tighten the two locking nuts onto the lower and upper pins. Do not tighten completely.
7. Position the loudspeaker and then tighten the locking nuts fully home.

3.2.5 GRILLE

For assembly, refer to Fig. 6.
If the grille is to be removed, slide the bar pins out starting from the top and then proceed downwards.

3.3 POSITIONING THE SPEAKERS

The Olympica Nova loudspeakers were designed to be easily driven in terms of sound amplification and
easy to integrate into any room.
Models I and II are more suitable for small-medium sized environments. For larger spaces, the V and III are
excellent.
To install a multi-channel or Home Theater system, it is possible to combine Center I, Center II (front central
channel) and Wall (lateral channels and surround) loudspeakers.
The most significant peculiarity of the Olympica Nova range regarding positioning in the environment, is
the "Stealth Ultraflex" side reflex channel combined with the possibility of using each speaker freely on the
right or left. This means the owner can choose to position the speakers with the reflex channel outlet facing
the pair internally or externally, according to the acoustic conditions of the room used or personal taste.
Refer to Fig. 7.
18