Pump Control - Siemens SITRANS LUT400 Betriebsanleitung

End of QS Flow Wizard
For QS to be successful, all changes must be applied.
Options
To transfer Quick Start values to the device and return to Program menu, press
DOWN arrow
Measurement mode.
Note:
It is strongly recommended that an
completion of the wizard to ensure best accuracy. See full Operating Instructions
for details.

1.2. Pump Control

Use this wizard to configure pumps if they will be used in your application. Be sure to first
complete the applicable Quick Start Wizard.
a) Press RIGHT arrow
MENU.
b) Press RIGHT arrow
c) Press DOWN arrow
d) At each step, press DOWN arrow
the next item, 
or RIGHT arrow
e) Scroll to desired item and press RIGHT arrow
DOWN arrow
f) At any time, you can press UP arrow
wizard.
Start of Wizard - Pump Control
Shows the type of Wizard to be executed.
Options
Number of Pumps
Select the number of pumps to be used with pump control.
Options
If set to NONE, pump control is disabled.
7ML19985XU81
BACK, CANCEL, FINISH (Display returns to 1. 1 .1 Quick Start menu when Quick
Start is successfully completed or cancelled. If CANCEL is selected, no
changes are written to the device.)
(Finish). Then press LEFT arrow
to activate PROGRAM mode and open menu level 1: MAIN
to navigate to menu item 1.1.
and RIGHT arrow
to open Edit mode: the current selection is highlighted.
to continue.
CANCEL, START
NONE, 2
Default: NONE
SITRANS LUT400 (HART)
three times to return to
2.15.2.Auto Zero Head
to open Pump Control.
to accept default values and move directly to
to store the change, then press
to go back, or LEFT arrow
be performed after
to cancel the
Page EN-29