Siemens SITRANS LUT400 Betriebsanleitung Seite 20

d) At each step, press DOWN arrow
accept default values and move directly to the
next item, 
or RIGHT arrow
current selection is highlighted.
e) Scroll to desired item and press RIGHT arrow
to store the change, then press DOWN
arrow to continue.
f) At any time, you can press UP arrow
wizard.
Start of QS Level Wizard
Shows the type of Wizard to be executed.
Options
Transducer
Specifies the Siemens transducer connected to the device.
Options
Operation
Sets the type of measurement (and the corresponding mA output) required for the
application.
distance
Mode
LEVEL
SPACE
DISTANCE
Page EN-18
to open Edit mode: the
CANCEL, START
NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
space
level
Description
* Height of material
Distance to material surface
SITRANS LUT400 (HART)
to
QUICK START LEVEL
QUICK START LEVEL
TRANSDUCER
NO TRANSDUCER
XRS-5
XPS-10
XPS-15
XCT-8
XCT-12
to go back, or LEFT arrow
High Calibration Point
Far Range
Reference point
Low Calibration Point
(process empty level)
High Calibration Point
(process full level)
Sensor Reference Point
(continued on next page)
TRANSDUCER
XRS-5
BACK
CANCEL EDIT
NEXT
to cancel the
sensor reference point
Low Calibration Point
7ML19985XU81