Size Mismatch In Tray; Standard Bin Full Remove All Paper From Bin; Supplies Low; Supplies Very Low To Continue, Touch "Ok - HP LaserJet Enterprise 700 M712 series Handbuch Zur Fehlerbehebung

Size mismatch in Tray <X>
Description
The paper in the listed tray does not match the size specified for that tray.
Recommended action
1. Load the correct paper.
2. Verify that the paper is positioned correctly.
3. Close the tray and verify that the control panel lists the correct paper size and type. Reconfigure
the size and type if necessary.
4.
If necessary, use the control-panel menus to reconfigure the size and type settings for the specified
tray.
5. Make sure that connectors J513, J507, and J501 are fully seated on the high-voltage power
supply.
6.
Make sure that connector J601 is fully seated on the DC controller PCA.
7.
If the error persists, replace the high-voltage power supply.
8.
If the error persists, replace the DC controller PCA.

Standard bin full Remove all paper from bin

Description
The specified output bin is full and must be emptied for printing to continue.
Recommended action
Empty the specified output bin.

Supplies low

Description
Multiple supplies on the product have reached the low threshold.
Recommended action
Replace the supply when print quality is no longer acceptable.
NOTE:
When an HP supply has reached its approximated end of life, the HP Premium Protection
Warranty ends.

Supplies very low To continue, touch "OK"

Description
More than one color supply on the product has reached the very low condition.
ENWW
Tools for troubleshooting
251