Changing The Unit Of Measure - Cressi DIGI 2 Benutzerhandbuch

EN
36
When the smart cover is removed, after a few seconds the display
will switch on automatically, running the launch procedure and
remaining on for two minutes.
After two minutes it will switch off automatically unless the DIGI 2
console is pressurized during that time, in which case it will remain
on for use.
P80-DIGI 2.indb 36

CHANGING THE UNIT OF MEASURE

To change the system for units of measure from metric (BAR, meters,
degrees Centigrade) to Imperial (PSI, feet, degrees Fahrenheit) or vice
versa depending on your needs, proceed as follows:
1. When the DIGI 2 console is switched on, turn it off by resting the
smart cover against it, respecting the orientation in the figure.
Remove the smart cover.
2. Wait for the launch sequence and repeat step 1.
3. Wait for the launch sequence and repeat step 1. Upon the next
relaunch, the units of measure will be different from those
shown before the procedure.
13/06/19 14:01