Flushing The Air Conditioning System - Waeco AirCon ServiceCenter ASC5000 Bedienungsanleitung

ASC5000, ASC5000G
8.8

Flushing the air conditioning system

I
NOTE
The "Flushing" menu is used to flush the vehicle air conditioning
system with fresh refrigerant. Flushing is especially suitable for
replacing old compressor oil or removing most metallic residue from the
system.
Before flushing, the refrigerant must first be extracted from the vehicle
air conditioning system. Afterwards, the system components which can-
not be flushed must be disconnected from the refrigerant circuit (for
example, the compressor or filter). After that, the components to be
flushed are connected to the service ports of the AirConServiceCenter
using special adapters to form a flushing circuit.
1. Start by fitting the connections of the AirConServiceCenter to the
vehicle air conditioning system, and opening them.
2. In the basic menu, use the cursor keys  or  to select
"Free selection":
3. Press ENTER to confirm.
4. If necessary, use the keypad (7) to enter the data and press ENTER
to confirm.
If no data is to be entered, press ENTER to switch to the next pro-
gram step.
5. Select "Rec/Recycling phase" (the setting flashes) and press
ENTER to confirm.
6. For the "Pressure increase Test time", enter 1 minute and press
ENTER to confirm.
7. Deselect "Vacuum phase" using No (the setting flashes) and press
ENTER to confirm.
8. Deselect "Filling phase" using No (the setting flashes) and press
ENTER to confirm.
9. Select "Process start" by pressing ENTER.
10. After the extraction process is complete, disconnect the station from
the vehicle.
EN
Short selection
Free selection
Other selections
ENTER-OK
Operation
97