GUTMANN Sombra Bedienungsanleitung Seite 15

accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen suffi-
ciently, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean
stainless steel surfaces with abrasive
scouring pads or with cleaning agents
containing sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Aluminium, varnished and plastic surfaces:
Use a soft micro fibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
Cleaning the Grease Filter
Risk of Fire!
The performance of the exhaust hood is
affected by greasy debris; the risk of fire
increases with the amount of deposits.
In order to prevent the risk of fire, regu-
lar cleaning of the metal filter is recom-
mended.
The necessity of cleaning the grease
filter is also displayed via the LED indi-
cators: The red LED on the ceiling de-
vice will begin to light up after 15 hours
of operation - when this happen, please
clean the filter. To do so, first gently
press the special glass pane upwards
with both hands.
The glass will slowly lift upwards and the
grease filter located beneath it can now
be removed. The metal filter is best
cleaned in a dishwasher with gentle dish-
washer detergent. The manufacturer of-
fers no guarantee in the event of possible
discoloration through the use of aggres-
sive cleaning products. Temperatures
above 55 degrees should also be
avoided.
Caution: Please do not use any 3 phase
cleaners or clean the filter in a commer-
cial dishwasher. Cleaning with aggressive
products such as benzene, acetone, tri-
chloroethylene, et cetera will lead to the
destruction of the filter!
Caution: Do not wash grease filter to-
gether with silver cutlery in the dish-
washer! This leads to destruction of the
grease filter (galvanic element, not a
complaint claim)
To replace the metal filter after cleaning,
lift the glass pane upwards again with
both hands and then held the switch to
the right for 10 seconds. The hours of
operation counter will be reset and the
red LED will go out.
en
15