Removing The Saw Blade; Working Instructions - Bosch 0 607 561 114 Handbuch

Type 0 607 561 116 Deadman switch
Switching on:
Press the on/off switch 5 and keep
5
it pressed down during the opera-
tion.
Switching off:
Release the on/off switch 5.
Type 0 607 561 118 / ... 120 Paddle style switch
Switching on:
Press the lever switch 4 and keep it
4
pressed down during the operation.
Switching off:
Release the lever switch 4.

Removing the Saw Blade

Disconnect the air hose from the air supply before
making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
When removing a saw blade, avoid contact with
skin and use proper protective gloves when
grasping the blade or accessory. Saw blades and
accessories may become hot during prolonged use.
To remove the saw blade, set the or-
bit selector switch 9 to setting III.
This position provides the easiest re-
moval access for the saw blade.
9
Push the orange-colored SDS blade change button 1
downward. This unlocks the barrel grip 2.
Turn the barrel grip 2 approximately three turns coun-
terclockwise.
13
11
Push the saw blade 11 gently in the directly of the bar-
rel grip, turn it 90°, and pull it out of the plunger 13.
3 609 929 250 • (04.07) T
1
2
English–9

Working Instructions

Disconnect the air hose from the air supply before
making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Excess loads that cause the tool to stall or reduce
speed will not damage the motor.
In the event of an interruption of the air supply
or reduced operating pressure, switch off the
tool. Check the operating pressure and start
again when the pressure returns to normal.
Use a saw blade that is appropriate for the thick-
ness of the workpiece. In its highest point of up-
and-down stroke, the saw blade should project
at least 10 % beyond the thickness of the work-
piece. This insures that the saw blade will not bind in
the workpiece and will help you achieve precise, clean
cuts.
Note that too high a feed rate reduces the output ca-
pacity substantially and shortens the life of the saw
blades. Sharp tool bits provide good cutting power
and protect the tool.
Always use a stable support or a bench when
small or thin workpieces are being cut. Thin work-
pieces may bend or vibrate during cutting and may no
longer be controllable.
Adjusting the Bevel
29
10
30
The footplate 10 can be adjusted to change the bevel
up to 45°.
Loosen the locking screw 29 by unscrewing it several
turns counterclockwise using the Allen wrench 3,
which is located in the footplate 10. Slide the footplate
10 in the direction of the saw blade and pivot it to the
right or to the left, depending on the desired bevel.
27
3
28