Husqvarna FS7000 D Bedienungsanweisung Seite 18

a) FS7000 D:
b) FS7000 DL:
CAUTION: Do not operate the product
without the blade guard latch engaged
and the front bolt of the blade guard
installed. Do not use the product if the
parts are damaged.
18. Start the product and listen for unusual sounds. If
there are unusual sounds, remove the cutting blade.
a) Examine the cutting blade for damages.
b) Install the cutting blade again. Replace the
cutting blade if it is damaged.
To remove the cutting blade
WARNING: When you remove diamond
blades, let the product become cool and use
protective gloves. Diamond blades are very
hot after use.
• Remove the cutting blade in the opposite sequence
of how it was installed. Refer to
blade on page 16 .
18
To install a cutting
To install a blade guard (FS7000 D,
FS7000 DL, 20-42 in.)
1. Lower the blade guard onto the supports (A), (B),
and (C).
A
2. Push the blade guard down until the blade guard
lock engages.
3. Connect the water hose.
All supports are not used for all blade guard dimensions.
• 14 in., 20 in. and 26 in. blade guards are lowered
onto the support (B) only.
• 30 in. blade guard is lowered onto the supports (B)
and (C).
• 36 in. and 42 in. blade guard is lowered onto all
supports (A), (B), and (C).
To install a blade guard (FS7000 DL,
48-60 in.)
1. Lower the blade guard on to the support screws (A),
(B), (C) and (D).
A
B
A
B
2. Push the blade guard down until the blade guard
lock engages.
3. Connect the water hose.
C
B
48"
C
D
60"
1223 - 002 - 09.07.2019