Powerlink - Lenze i550 Montage- Und Einschaltanleitung

POWERLINK

Typical topologies
MN Managing Node
CN Controlled Node
Bus-related information
Name
Communication medium
Use
Connection system
Status display
Connection designation
Status displays at the RJ45 sockets
The LEDs at the RJ45 sockets indicate the connection status to the network:
LED (green)
off
on
flickers
LED (red)
on
Basic network settings
The rotary encoder switch allows you to set the node address (last byte of the IP address).
Setting
0x00
0x01 ... 0xEF
MN
CN11
H1
CN21
H2
Ethernet POWERLINK
Ethernet 100 Mbps, half duplex
Connection of the inverter to a
POWERLINK network
RJ45
2 LEDs
IN: X286
OUT: X287
Status/meaning
No connection to the network.
A physical connection to the network is available.
Data is exchanged via the network.
Status/meaning
POWERLINK collision
x16
Node address
Value from parameter
Switch position
Line
CN1n
CN12
CN22 CN2n
H Hub
x1
Resulting IP address
192.168.100.<parameter value>
192.168.100.<switch position>
Electrical installation
Networks
POWERLINK
177