Safety Instructions For Inspection And Installation Work; Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage - Wilo -VeroLine-IPH-O Einbau- Und Betriebsanleitung

2.6 Safety instructions for inspection
and installation work
2.7 Unauthorised modification and
manufacture of spare parts
2.8

Improper use

3

Transport and interim storage

3.1

Shipping

Transport inspection
Storage
3.2 Transport for installation/
dismantling purposes
Fig. 5: Attaching the transport ropes
Installation and operating instructions Wilo-VeroLine-IPH-O, IPH-W
The operator must ensure that all installation and maintenance work
is carried out by authorised and qualified personnel who are suffi-
ciently informed from their own detailed study of the operating
instructions.
Work to the product/unit must only be carried out when at a standstill.
It is mandatory that the procedure described in the installation and
operating instructions for shutting down the product/unit are com-
plied with.
Immediately on conclusion of the work, all safety and protective
devices must be put back in position and/or recommissioned.
Unauthorised modification and manufacture of spare parts will impair
the safety of the product/personnel and will make void the manufac-
turer's declarations regarding safety.
Modifications to the product are only permissible after consultation
with the manufacturer. Original spare parts and accessories author-
ised by the manufacturer ensure safety. The use of other parts will
absolve us of liability for consequential events.
The operating safety of the supplied product is only guaranteed for
conventional use in accordance with Chapter 4 of the operating
instructions. The limit values must on no account fall under or exceed
those specified in the catalogue/data sheet.
The pump is enclosed in a box or lashed to a pallet ex works and is pro-
tected against dirt and moisture.
On arrival, inspect the pump immediately for any transport damage.
If damage is detected, the necessary steps involving the forwarding
agent must be taken within the specified period.
Before installation and/or during interim storage, the pump must be
kept dry, frost-free and protected from mechanical damage.
CAUTION! Risk of damage due to incorrect packaging!
If the pump is transported again at a later time, it must be packaged
so that it cannot be damaged during transport.
• Use the original packaging for this, or choose equivalent packag-
ing.
WARNING! Risk of injury!
Improper transport can lead to personal injury.
• The pump must be transported using approved load bearing equip-
ment. This is to be attached to the pump flanges and, if necessary,
to the outer motor diameter (safety device to protect against slip-
ping required!).
• Transport eyes can be screwed into the threaded holes provided on
the motor for that purpose. These eyes must only be used for guid-
ing while bearing the load (fig. 5).
• To lift with a crane, the pump must be supported by suitable belts,
as shown. Place loops around the pump which tighten from the
pump's own weight.
• If transport eyes are attached to the motor, they are only approved
for transporting the motor, not the complete pump (fig. 6).
English
21