Appliance Description; Accessories; Operation; Symbols - STIEBEL ELTRON STE Inbetriebnahme

COmmISSIONING

Appliance description

3. Appliance description
The appliance is responsible for the processes that control and
regulate the heat pump. The appliance allows remote monitoring
and heating system control via the internet.
If multiple heat demands exist simultaneously, the appliance
switches back and forth between the demands. If a booster heater
is activated, DHW heating can run at the same time as the heating
mode and swimming pool heating.
3.1

Accessories

The following accessories can be installed for additional control
of the heat pump.
- Extension module
4.

Operation

4.1

Symbols

Additional symbols are explained in the corresponding chapter.
Symbol meaning
Call up main menu
Call up start screen
Authorisation code required
Confirm settings
Unconfirmed settings are reset to the previous
value.
Cancel settings
Scroll back one page
Scroll forward one page
Back
Reset to factory settings
The values on the current menu page are reset
to the factory settings.
Activate or deactivate functions
ON
The symbol shows the activated function.
Activate or deactivate functions
OFF
The symbol shows the deactivated function.
Select one of two options
0
www.stiebel-eltron.com
Symbol meaning
Select one of two options
1
5. Commissioning
Note
If a restart of the heat pump is required, the symbol is
displayed on the appliance.
Note
Some setting options are only available in safe mode.
Once you have entered the access code, it does not need
to be re-entered for eight hours. The remaining time is
displayed top left of the screen.
f Press the button on the start screen to open the main f
menu.
f Press the button to access safe mode. f
f Enter the following access code: 607080 f
f Confirm the selection. f
5.1

Setting the language

f Press the button on the start screen to open the main f
menu.
f Press the button. f
f Press the "Language" menu. f
f Press the button to access the required language. f
f Select the required language. f
either
f Press the button to return to the higher ranking f
menu.
or
f Press the button to return to the main menu. f
5.2

Setting date and time

Note
The primary heat pump transfers the date and time set-
tings to the secondary heat pumps.
STE | 29