Klarstein 10028451 Handbuch Seite 9

Figure 1: A distance of 600mm from bottom
of heater to floor is recommended for optimum
viewing of fuel bed; see Fig.1 for recommend
fixing dimensions.
Ensure that the bracket is level by using a Spirit level whilst marking out the hole positions. Drill
holes with a No. six drill bit. Fix the wall bracket using that the plug and screws provided. Attach the
lower fixing bracket the base of the fire using the two small black screws supplied; ensure the bracket
is fitted so that it is level with the back. Carefully lift the heater up ensuring that the top rear ledge of
heater engages with the wall bracket (see Fig.2 in circle) and is sitting centrally. This process should
be carried out by two people to avoid injury or damage to property or the appliance. Gently bring the
heater down against the wall.
Figure 3: Mark the lower fixing bracket two fix-
ing hole positions on the wall-see Fig.3, remove
the heater. Drill the wall and insert the wall
plugs. Refit the heater to the wall and fasten
the bottom fixing bracket to the wall using the
screws provided to permanently fix the heater
in place.
9
Figure 2: For optimum viewing, mark the top
four screws fixing positions on wall in accord-
ance with the recommend fixing dimensions
Figure 4: Place the front surround over the
front of the fire aligning the slots in the brack-
ets at each side of the front panel with the
lugs on the sides of the fire-see Fig.4. Again
two people will be required for this operation.