Testing The Remote Control - Geberit AQUACLEAN TUMA series Montageanleitung

If several devices of the same type are
installed in immediate proximity (e.g. in
hotels), remote control must be assigned to
a device.
If the device does not beep and the LED on
the lateral control panel does not light up
blue for several seconds, then the remote
control must be re-assigned.
Re-assigning the remote control
This section only applies to the Comfort
model.
If the device cannot be controlled using the remote
control, then the remote control must be re-
assigned.
4
Press the <+> button on the remote control
and the <+> button on the lateral control
panel at the same time for approx. 10
seconds.
Result
ü The device beeps (1x).
ü The LED on the lateral control panel lights up
blue for several seconds.
27021599673220363-1 © 11-2017
967.305.00.0 (02)

Testing the remote control

This section only applies to the Comfort
model.
Prerequisite
– The remote control has been set up.
– User is simulated.
1
Press the <Shower> button briefly in order
to start the anal shower with oscillating
function.
ü The device performs a shower cycle.
A shower cycle ends after 50 seconds. If
required, restart the shower cycle.
EN
25