Operation - auna 10031933 Bedienungsanleitung

OPERATION

Please note before use
• - Remove the stylus protector.
• - Make sure that the tone arm is unlocked
and free to move from the tone arm rest
prior to operating. Lock the tone arm
again when not in use.
1. Raise the turntable dust cover.
2. Place the record on the platter (use the 45 RPM record adaptor if you are
playing 45 RPM records).
3. Set the speed selector (4) to the proper
position for the record you are playing.
4. Set the cueing lever (5) to the up position.
5. Lift the tone arm from the rest and slowly
move it to the record side. The platter will
start to rotate and position the tone arm
over the desired position of the record.
6. Pull down the cueing lever (5). The tone arm
will come slowly on the record and start playback.
7. At the end of the record, the tone arm will return to the rest position
automatically.
8. To stop manually, lift the tone arm from the record and return to the rest.
Play suspension
Set the cueing lever (5) to the up position will life up the tone arm and then
stop playback temporarily.
Remark :
Due to mechanical design of the auto returen system and reset point will
be affected after transportation. Thus, the tone arm will return to the rest
automatically when first time place it to the platter and it was not the
malfunction.
Due to the length of the record is various, if you find the tone arm cannot
return automatically after playback of record. Please adjust the Tone arm
stopping position as below.
This turntable system is using a magnetic cartridge system and user must
EN
15