Installation; Setup And Operation - auna TT-Play SE Handbuch

EN
20

INSTALLATION

Making the power connection
Note: Only use the power adapter included in the scope of delivery.
• Plug the DC connector of the AC adapter into the DC IN connector on
the back of the unit.
• Insert the AC plug of the AC adapter into a grounded power outlet.
• Press the Power button on the back of the machine to turn it on.
Amplifier connection (if necessary)
You can play the music through the unit's speakers or connect the unit to an
external speaker system.
• Connect the LINE OUT terminal of this unit to the mixer or amplifier
using an RCA cable (not supplied).
• The red connector must be plugged into the right channel input.
• The white connector must be plugged into the left channel input.
Note: When a line-out connection is made, the volume cannot be
controlled from the unit itself.

SETUP AND OPERATION

Before starting playback
• Remove the protective cap from the needle.
• Make sure that the tonearm can be moved freely from the tonearm
holder.
• When the machine is not in use, place the tonearm on the tonearm
holder.
• Replace the protective cap on the needle when the machine is not in
use.