Manually Controlling The Fan Level - Boneco P700 Gebrauchsanweisung

REGUL ATING THE POWER
ABOUT THE AUTO MODE
The BONECO P700 is fully automated in
mode. The fan levels are determined based on the values
measured by the particle sensor. The fan power increases
automatically in room air that is heavily polluted. Fan
power is reduced as the air becomes cleaner.
ABOUT THE MANUAL CONTROL SYSTEM
In most cases, mode is the best choice. If, however,
you are running the BONECO P700 in a special situation,
such as in your bedroom at night, a manually selected
fan level provides minimal, consistent background noise.
ACTIVATING AUTO MODE
comfort If you are putting the appliance into operation for the first
time or if the power supply has been interrupted,
mode is active.

MANUALLY CONTROLLING THE FAN LEVEL

To switch from mode and to use a different fan
level, press the button repeatedly until the desired
level is reached.
mode is deactivated automatically the first time the
button is pressed.
RESTORING AUTO MODE
To restore mode, touch the
The icon is shown on the display.
POWER MODE (P)
The P power mode can only be selected manually. Use
this setting to clean very dirty indoor air in the shortest
amount of time.
1. Press the
is shown on the display. The fan then works at its
maximum output regardless of the measured air pol-
lution.
button once.
25
button repeatedly until the P fan level
en