The unit is factory set as follows:
NOTE
Detailed information about the operating modes are contained in the
appendix "Technical Information".
Sublimation Controller Switching ON
To switch ON the Sublimation Controller switch the power switch
located on the rear panel to the "1" position.
To start the sublimation, push the "SUBLIMATION" key located on
the front panel then press ▲ or ▼ to change the display to:
S
Press SET key to start the sublimation.
Until the above sequence is not concluded, the sublimation will not start and the
NOTE
unit will wait for a parameters setting.
TSP Controller User Manual
MANUAL operating mode
TSP source type
sublimation current 30 A
sublimation time 1 minute
sublimation period 3 minutes
pressure threshold 1x10
"AUTOSTART" on "YES" (automatic restart before power failure)
U
B
L
I
M
S
T
A
R
T
/
87-900-138-01
Operating Procedures
mbar
-7
A
T
I
O
N
?
Y
E
Instructions for Use
S
M
A
71/127
4
N