Werbung
5
Technical Information
Use
The Sublimation Controller escape automatically from the current setting before
NOTE
30 second, if no selection are made, and return to sublimation operation.
Operation in AUTOMATIC Mode
After the start confirmation (by press SET key at the message
"SUBLIMATION START ? YES") the sublimation begin when the
pressure measured (incoming to the I/O connector) reach the
pressure threshold set. In this operation mode the display shows:
S
To end sublimation press the SUBLIMATION key and the relevant
Led is turned off.
Operation in REMOTE SET Mode
The operation is the same previously described for MANUAL
operation, but the current depends on the signal incoming to the I/O
connector.
To end sublimation, press the SUBLIMATION key and the relevant
Led is turned off.
In this operating mode it is possible to display the current measured
on the incoming signal on the I/O connector pressing SET key. The
display shows:
I
To escape from this message press the SET key again or wait
30 second without pressing any key.
102/127
U
B
L
.
X
X
X
X
X
m
i
s
=
P
R
E
S
S
m
b
a
r
X
X
.
X
TSP Controller User Manual / 87-900-138-01
U
R
E
A
R
E
M
Werbung
Kapitel
