Lupine Piko 4 Bedienungsanleitung Seite 17

2
Operation light
Switching on:
The first press of the button switches on the light with maximum power.
The blue LED is illuminated.
Switching:
Each quick push of the button switches from
Note: The light outputs the maximum amount of light only if airflow lowers
the temperature of the light sufficiently. If the light is not cooled by airflow,
its power is reduced incrementally to prevent the LEDs and electronic ele-
ments from overheating.
Switching off:
To switch off the lamp, keep the button pressed.
Battery warning indicator:
The red LED indicates the state of the battery. If the battery voltage decreases
below a certain value, first the red LED is illuminated (the lamp itself also fla-
shes once) and additionally, shortly before the capacity is entirely exhausted,
it starts flashing.
Warning! When the battery is completely discharged (the
red LED has been flashing for a few minutes), the red and
blue LED flash in turn, the lamp flashes. Stop immediately!
The light will be switched off after flashing several times.
Note: The burn time remaining after the
the total battery capacity, the ambient temperature and the battery's age.
32 Piko
high to middle to low beam.
Lamp on
Battery partly discharged
Very low capacity
red LED is illuminated depends on
Battery empty (lamp flashes)
Reserve power:
When the battery is discharged ( the red and blue LED has been flashing for
some minutes), the lamp flashes several times and is then switched off. After
switching the light on again (double click!), reserve power is available. Depen-
ding on the age of the battery, some more minutes of light are provided. To
make reserve power last as long as possible, only light below 2 W is provided.
To indicate that reserve power is activated, the red and blue LEDs
When reserve power is completely discharged, the light will be switched off
automatically. So slow down!
Note: If the lamp has only been used with up to 2W,
Warning: Do not switch on the light when the battery is
discharged, as this will invariably damage the battery.
Recharge the battery as soon as possible to avoid a deep
discharged battery.
Explanation of LEDs:
Blue LED on:
Red LED on:
Red LED flashing:
lights flashing:
The blue and the
red LED flash in turn,
the lamp flashes:
The blue and the
red LED flash in turn:
flash in turn.
Reserve power
reserve power is not available.
lamp on
low battery, save power!
battery almost empty,
stop immediately!
The battery is empty
The lamp is running
on reserve power
2
Piko 33