Test Light Instructions
Note: If the Test Light does not fl ash, recharge the battery and re-test. If Test Light still does not fl ash,
contact the Customer Care Centre or visit our website at www.petsafe.net.
Important: The Test Light Tool can be used to tighten the Contact Points. This Receiver
Collar has special waterproof Contact Points that will crack if they are over-tightened.
If your Contact Points ever become loose, do not turn them any more than one-quarter
turn beyond fi nger tight.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modifi cation of the
terms, conditions and notices contained herein. Usage of this product implies acceptance of all
such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specifi c temperament of
your pet may not work with this product. We recommend that you not use this product if your pet
is less than 3.6 kg or under 6 months old, or if your pet is aggressive. If you are unsure whether
this is appropriate for your pet, please consult your veterinarian, certifi ed trainer or contact our
Customer Care Centre or visit our website at www.petsafe.net.
Proper use includes reviewing the entire Operating and Training Guide provided with your
product and any specifi c Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm,
injure, or provoke. Using this product in a way that is not intended could result in violation of
Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental,
special or consequential damages, or any damages whatsoever arising out of or connected with the
use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
5. Modifi cation of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under
which this Product is offered.
1. Turn the Receiver Collar on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will fl ash.
Note: At higher Stimulation Levels, the Test Light will fl ash
brighter.
5. Turn the Receiver Collar off.
Save the Test Light for future testing.
www.petsafe.net
21