Connecting The Cables - Siemens SCALANCE W786-2HPW Betriebsanleitung

Connecting up

4.3 Connecting the cables

Antenna connector: N-Connect/ N-Connect connecting cable
4.3 Connecting the cables
Procedure
30
Siemens Drives & PLCs
The N-Connect/N-Connect male/male flexible connecting cable is available as an accessory
for connection of an antenna to the lightning protector LP798-1N.
Length in m
1
2
5
10
There is a control cabinet feedthrough available for IWLAN devices located in a control
cabinet. You will find detailed information in the catalog IK PI.
WARNING
Danger from line voltage
If the housing is not perfectly sealed, there is a danger to life due to the line voltage if the
SCALANCE W786 is subjected to spray water or dampness. Make sure that you keep to
the following safety rules.
• Before connecting up, turn of the power supply.
• The sealing of the cable feedthroughs of the SCALANCE W786 is only assured when
the cable has a suitable diameter and adequate tensile strength. Only use cables that
meet the specifications in the section "Cables for the SCALANCE W786". When
connecting up a FO cable, make sure that you use the adhesive sealing foil supplied
with the SCALANCE W786.
• Never wrap insulating tape, adhesive tape or other materials around thinner cables to
achieve the required diameter. In this case, neither the housing seal nor the strain relief
clamps can fulfill their function.
• Close all unused openings in the housing seal with the sealing plugs supplied with the
SCALANCE W786. Do not use fillers or any other material under any circumstances.
Order number
6XV1875-5AH10
6XV1875-5AH20
6XV1875-5AH50
6XV1875-5AN10
SCALANCE W786-2HPW
Operating Instructions (Compact), 06/2007, A5E01186485