Fitting The Mounting Plate To An S7 Standard Rail - Siemens SCALANCE W786-2HPW Betriebsanleitung

3.4.3

Fitting the mounting plate to an S7 standard rail

Procedure
A
Figure 3-10
Follow the steps below to fit the mounting plate to an S7 standard rail:
1. Place the mounting plate with the two protruding catches on the top edge of the S7
standard rail (position A in the figure above).
2. At the bottom, the mounting plate has two lugs with holes. Screw the lugs to the S7
standard rail (position B in the figure above). The required screws are supplied with the
mounting plate.
SCALANCE W786-2HPW
Operating Instructions (Compact), 06/2007, A5E01186485
B
Side view of a mounting plate on an S7 standard rail
Mounting
3.4 Mounting with mounting plate
21