Fitting The Scalance W786 To A Mounting Plate - Siemens SCALANCE W786-2HPW Betriebsanleitung

Mounting
3.4 Mounting with mounting plate
3.4.6

Fitting the SCALANCE W786 to a mounting plate

Procedure
24
Siemens Drives & PLCs
1
B
C
2
Figure 3-13 Fitting the SCALANCE W786 to a mounting plate
Follow the steps below to fit a SCALANCE W786 to a mounting plate:
1. Lead the cables into the housing of the SCALANCE W786 (position A in the figure
above). Note the information in the section "Connecting up cables".
2. Fit the SCALANCE W786 so that the upper edge of the rear of the housing is below the
two catches of the mounting plate (position B in the figure above).
3. Push in the SCALANCE W786 until it engages in the notches at the lower edge of the
mounting plate (position C in the figure above).
A
SCALANCE W786-2HPW
Operating Instructions (Compact), 06/2007, A5E01186485