Dmx Linking - Chauvet fallout Kurzanleitung

Fallout™ QRG
DIP Switch
Basic
Operation

DMX Linking

Starting Address
Master/Slave
Connection
DMX Values
4-CH
Channel Function
To operate the DIP switch located at the front of the product, simply flip the
switch up to turn the switch on. Flip it down to turn it off. More than one
switch can be active at one time. For more detailed information on the
Fallout™'s DIP switch functionality, refer to the product's User Manual,
located at www.chauvetlighting.com.
DIP S
WITCH
1
2
3
4
5
6
7
8
9
10
The Fallout™ can work with a DMX controller when linked by DMX serial
connections. Instructions for connecting and configuring this product for
DMX operation are in the User Manual. If you are not familiar with DMX,
download the DMX Primer from www.chauvetlighting.com.
To ensure full access to all channels in each DMX mode, the highest
recommended DMX address is 509.
The Fallout™ uses the DMX data connection for its Master/Slave mode.
Instructions for connecting and configuring this product for Master/Slave
operation are in the User Manual.
1 Operating Mode
2 Strobe
3 Auto Run Speed
4 Motor Speed
F
UNCTION
Red
Green
Blue
Strobe Speed 1
Strobe Speed 2
Strobe Speed 3
Strobe Speed 4
Strobe Speed 5
Sound Active Mode
Automatic Mode
Value Percent/Setting
000  020 Blackout
021  040 Red
041  060 Green
061  080 Blue
081  100 Red/Green
101  120 Red/Blue
121  140 Green/Blue
141  160 RGB
161  180 Automatic mode 1
181  200 Automatic mode 2
201  220 Automatic mode 3
221  240 Automatic mode 4
241  255 Sound active mode
000  009 No function
010  255 Slow to fast (when Ch. 1 is 021~240)
000  255 Slow to fast (when Ch. 1 is 161~240)
000  009 Stop
010  255 Slow to fast (when Ch. 1 is 021~240)
4
EN