Troubleshooting - Fellowes POWERSHRED 450Ms Anleitungen

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after
each pass to clear entry. Continuous
operation beyond 8-minutes will
trigger 15-minute cool down period.
ADVANCED PRODUCT FEATURES
SafeSense ® Technology
Stops shredding immediately when
hands touch the paper opening.
SAFESENSE TECHNOLOGY
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Turn the shredder ON Touch test area and
(I) to activate SafeSense look for the SafeSense
®
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
PAPER/CARD OR CD
1 2
Plug in and Feed paper/card
turn ON (I) straight into paper
entry and release
3
SafeSense is active and
®
working properly
®
3
or
Hold CD at edge, feed
into center of entry
and release
SilentShred™ Technology
Shreds without noisy disruptions
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry.)
TO CLEAN THE SENSORS
1
2
Turn OFF (O) and Locate Auto-start
unplug shredder infrared sensor
® indicator will illuminate and the shredder will stop shredding.
When finished
shredding set to
OFF (O)
3
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
4
3