Troubleshooting - Fellowes LX Serie Handbuch

ADVANCED PRODUCT FEATURES
Intelli
BAR
With 5 Responsive Features. The revolutionary fearless
shredder lineup that maximizes workplace efficiency and
keeps your day in flow.
. .
1. Run Time Indicator:
Light will turn yellow when machine is
close to the maximum runtime and switch
to red when cool down is needed
2. SafeSense Technology:
®
Light will turn yellow to alert when system is
activated. Machine will turn off after 5 seconds
of hands touching the paper entry (open bin or
switch power on/off to resume shredding)
3. Reverse:
Light will turn green
4. Forward:
Light will turn green
PRODUCT MAINTENANCE
OILING SHREDDER
All mini-cut
oiled, a machine may experience diminished sheet capacity,
intrusive noise when shredding and could ultimately stop
running. To avoid these problems, we recommend you oil your
shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
1
*Only use a non-aerosol
vegetable oil in long
nozzle container such as
Fellowes 35250
Press and hold forward ( >)
2
2-3 seconds

TROUBLESHOOTING

OVERHEAT
INDICATOR
Overheat Indicator: When the Overheat Indicator is
illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for
the duration of the recovery time.
Bin Open: The shredder will not run if the bin is open. When
illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and
needs to be emptied. Use Fellowes waste bag 36052 (LX200/
LX210), 36053 (LX220).
™
.
.
BIN BIN
OPEN FULL
Energy saving feature shuts down automatically after 2
minutes of no shredding activity. Insert paper, press forward/
reverse or open and close the bin to resume shredding.
. .
5. Bin Open:
Light will turn red when bin is pulled out
6. Bin Full Indicator:
Light will turn yellow when nearly full and
turn red when it needs to be emptied
7. Efficiency Meter:
Light will turn blue when powered on and ready.
Light will expand green and when optimal shredding
zone is reached it will pulse. Once the optimal level
is surpassed, the light will turn yellow, then red to
the light will turn red and paper will auto reverse.
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free
operation. However, on rare occasions the sensors may
become blocked by paper dust causing the motor to run
even if there is no paper present. (Note: two paper detection
sensors are located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Turn off Locate Auto-
disconnect start infrared
power switch sensor
(O) and unplug
the shredder
SAFESENSE
INDICATOR
SafeSense Indicator: If hands are too close to the paper
®
entry, the SafeSense
will stop shredding. If SafeSense
shredder will automatically turn off and the user must open and
close the bin or toggle on/off the power switch on the rear.
Power: If the machine is not powered, ensure the power
switch is in the ON (I) position and the power cord is plugged
into both the machine and power outlet.
.
3
Dip cotton
swab in
rubbing
alcohol
POWER
®
SWITCH
indicator will illuminate and the shredder
®
is active for 5 seconds, the
®
4
Using cotton
swab, wipe
away any
contamination
from the paper
sensors
3