Programming Of Internal Call Addresses; Internal Call Addresses, The Indoor Station Responds To - sks BS2012 Installationsanleitung

SKS-Kinkel Elektronik GmbH
20002110 BS2012 Audio Hands-free
Step
3
4
5
6
7
8
8.4

Programming of internal call addresses

8.4.1

Internal call addresses, the indoor station responds to

If internal calls are planned for a system, all relevant call addresses for each indoor station have to be pro-
grammed into it. The indoor station BS2012 Audio Hands-free has four storage places for call addresses, the first
of which is always used for its own call address, which responds to calls coming in from the door station (ringing
the bell at the door station) and which identifies the indoor station.
Additionally three more call addresses can be programmed, the indoor station responds to, e. g. to incoming
internal calls (= communication between two indoor stations), group calls (= communication between one indoor
station with up to four other indoor stations) or to further calls from the door station (= call addresses responding
to further bell buttons at the door station(s).
To program internal call addresses, the indoor station responds to (= receiving indoor station) follow these steps:
Step
1
2
3
4
5
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Description
Keep hold of the programming button at the back of the device for about five
seconds until you hear a signal tone.
After this signal tone you will hear another short tone signalling that the programming has
been successful.
Change the DIP switch to the second call address (= 2
which responds to internal calls send to this indoor station.
Keep hold of the programming button at the back of the device for about five
seconds until you hear a signal tone.
After this signal tone you will hear another two short tones when programming the second call
address, three for the third and four for the forth call address programmed, so that you know
exactly which call address has been saved in which position (1 to 4) on your storage space.
To program further call addresses repeat steps 5 to 7. If you try to program more than four
call addresses this will be refused and signalled by a respective tone.
Description
If unsure whether call addresses have already been programmed into the indoor station or
which call addresses have been programmed we recommend to delete all call addresses
saved in the indoor station (see next chapter „Deleting all call addresses").
Switch the DIP switch to the main call address (= 1
responds to calls made from the respective bell button at the door station.
Keep hold of the programming button at the back of the device for five seconds
until you hear a signal tone.
After this signal tone you will hear another short tone signalling that the programming has
been successful.
Change the DIP switch to the internal call address (= 2
which responds to internal calls send to this indoor station.
st
30
position in your storage space)
nd
position in your storage space) which
position in your storage space)
nd
Version No. 3.0
Document No. 97000104
EN