Preparing The Product For Use; Contents And Unpacking; Safely Disposing Of Packaging Material; Assembling And Installing - Videotec HEB26 Bedienungsanleitung

5 Preparing the product
for use
Any change that is not expressly approved
h
by the manufacturer will invalidate the
guarantee.

5.1 Contents and unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• HEB Housing
• Housing equipment:
• Allen wrenchs
• Spacers
• Screws and washers for camera
• Desiccant salt bag
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
4
6 Assembling and
installing
Only specialised personnel should be
h
allowed to assemble and install the device.

6.1 Installation

Turn off the power before performing any
g
kind of operation.

6.1.1 How to open the housing

To open the housing, unscrew the two screws placed
on the side in the middle of the rear cover plate (01),
take the body out (02), hang it onto the suitable
holder (Fig. 02, page 4) and leave the internal and
external slide in the working position. Before closing
the housing take off the protective nylon and put
silicagel salts envelope into.
02
01
Fig. 01
Fig. 02
03